TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
14' Lone Star Project
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Steph Boeker" data-source="post: 501293" data-attributes="member: 32953"><p>I don't know if it will be so impossible. Take it slow. Heat helps w/the bending. Propane will take a while but MAP gas (like propane) would heat faster & hotter than propane. Just don't stay in one place too long, you wouldn't want to burn through it. </p><p>Hammer & dolly or a plastic sand filled hammer even. Little at a time.</p><p>Here's an advertisement someone shared a while back.</p><p>Hope this helps and take lots of photos. </p><p>Good luck.</p></blockquote><p></p>
[QUOTE="Steph Boeker, post: 501293, member: 32953"] I don't know if it will be so impossible. Take it slow. Heat helps w/the bending. Propane will take a while but MAP gas (like propane) would heat faster & hotter than propane. Just don't stay in one place too long, you wouldn't want to burn through it. Hammer & dolly or a plastic sand filled hammer even. Little at a time. Here's an advertisement someone shared a while back. Hope this helps and take lots of photos. Good luck. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
14' Lone Star Project
Top