thegr8cody
Well-known member
- Joined
- Nov 22, 2011
- Messages
- 155
- Reaction score
- 0
Theyre not finishe, I have to wait till Thursday before I can get the pvc and my new lights. These were really simple to make.strangth was not really an issue as I use my side boards for guides I just made these for when im backing IP and to quit dunking my lights. I just used some angle iron and cut two pieces about 40" and cut a slit in one side so I can bend it. I plan on using some self tapping screws and bolts to secure it to the light bracket. Hope this helps people make there own
I was hopin to keep my bracket under the light bracket to hide how ugly it is but that interfered with the angle on my lights so that didnt wprk. Decided to mount them up top, they look decent and are very sturdy and snug. Total cost was about $10, pipe was $6 caps were 1.25 a piece then I needed galvanized hardware. Beats paying $70 from the store
I was hopin to keep my bracket under the light bracket to hide how ugly it is but that interfered with the angle on my lights so that didnt wprk. Decided to mount them up top, they look decent and are very sturdy and snug. Total cost was about $10, pipe was $6 caps were 1.25 a piece then I needed galvanized hardware. Beats paying $70 from the store