I recently purchased my first tin,trailer,motor from someone
On craiglist. When I went to look at it the guy said motor runs good
(Evinrude 9.5 ) he then pulled rope and fired right up,ran about 5seconds
Then he shut off because it wasn't in water. Also gave me a 6galtank
But didn't have the hose and bulb. Today I went and put gas in
The tank attached the new line I purchased from Wal-Mart ,arrow on bulb
Pointing towards engine, pumped and pumped and pumped some more
And no pressure was building? Took line off at engine pushed in the little check ball
And pumped some more....no fuel coming out??? Then I tried pulling the
Rope and the gear would just spin it wasn't lifting up
Into the flywheel, i would then lift it in to it to engage
The gears but motor wouldn't start even with spraying wd40 into carb
Does any one have any suggestions as to why I couldn't get fuel to flow
And maybe what to look for on starting motor?
On craiglist. When I went to look at it the guy said motor runs good
(Evinrude 9.5 ) he then pulled rope and fired right up,ran about 5seconds
Then he shut off because it wasn't in water. Also gave me a 6galtank
But didn't have the hose and bulb. Today I went and put gas in
The tank attached the new line I purchased from Wal-Mart ,arrow on bulb
Pointing towards engine, pumped and pumped and pumped some more
And no pressure was building? Took line off at engine pushed in the little check ball
And pumped some more....no fuel coming out??? Then I tried pulling the
Rope and the gear would just spin it wasn't lifting up
Into the flywheel, i would then lift it in to it to engage
The gears but motor wouldn't start even with spraying wd40 into carb
Does any one have any suggestions as to why I couldn't get fuel to flow
And maybe what to look for on starting motor?