duckweed
Member
I have a crack between the end of a rib and the transom on the bottom of my boat. I believe the crack was caused because the bunk was too short. I replaced the bunks. The bottom of the boat has steelflex but it cracked with the aluminum. I had to clean it off in order to get it welded, which was not an easy task. The boat was taking on a little over a gallon per hour in the water. I had it welded but it is still dripping a little, but no where near as much as it was. Should I take it back to the welder or just epoxy the weld?
My only reservation with taking it back is the guy don't weld aluminum very often and there is not a guarantee it won't leak again or worse on the second try.
Any ideas and what would you do?
Thanks
My only reservation with taking it back is the guy don't weld aluminum very often and there is not a guarantee it won't leak again or worse on the second try.
Any ideas and what would you do?
Thanks