Riverdog, thanks for the reply. My 9.9 outboard has three tilt positions that I have to control manually... ie, adjust the tilt knob and then raise and lower the engine so it then adjusts to the new tilt position. So its kind of a pain.
Lowrance suggests that I relocate the transducer further...
I'm perplexed as to whether or not my setup will allow me to replace my existing transducer with one that will give me side scan/imaging.
I have a 14' long aluminum jon boat. The transom is 36" wide. I want to upgrade the black and white monitor fish finder I have that is accompanied by a...
Mr Giggles, my seat is offset to the right, and my cone angle for the transducer is only 20 degrees, so although it would make sense to put the transducer on the port side for verticle jig Fishing over the fish that I would see on the sonar display, the turbulence from the outboard propeller...
I have a 1436 Alumacraft Jon boat and want to mount my small 83/200 kHz Skimmer Transducer to the starboard side of the transom. I will be adding a small plastic mounting plate first and screwing the transducer to it.
I have a 9.9 HP outboard.
About half way between the Plug hole in the center...