Latest activity

I would seriously consider a mid 90's Jonyrude 9.9 two stroke, under 70 lbs and much better performance than a four stroke. I had a 94...

The bunks should fully support the transom. Extending them 3/4 to an inch beyond the transom is good. There might be some bad news...

An awfull lot depends on quality control for that day. If you look closely, that is not uncommon on riveted boats and can happen on...

An awfull lot depends on quality control for that day. If you look closely, that is not uncommon on riveted boats and can happen on...

Try this maybe. Used on old ford cars sometimes.

Your motor will pull fuel a long way as long as it doesn' t make a steep incline. Most folks try to keep long fuel lines reasonably...

Hello, Does anyone know the chine width of the Starcraft Alaskan 13 at the transom? Thanks, Michael

The original tank was a metal behemoth that the previous owner let slide aound in front of the rear seat. My motor is an old Johnson 8...

Easy to put your tank on the front or rear side of that middle seat. A bracket can be made to hold the tank in place and attached to the...

How big is the tank? Not knowing your motor and fuel arrangement now, I can only tell you about my boat. I have a 20HP Merc pushing my...

Media sure plays the narrative differently when it's one of theirs.

Hi, I have a 1989 16' Starcraft I need to redo a patch on. My thought was to use 3M 5200 or G/Flex, aluminum sheet on outside and...

I had a 15 Gamefisher, and that thing was LIGHT, on the order of 55 lbs. I dont' think it weighed as much as a bucket of drywall mud...

I replaced thevtransom on my jon boat with a piece of exterior plywood and covered it in thompsons waterseal, now it doesn't sit out...

Ok I have an update, I found a tiller steering bracket that bolted up to my Johnson 35hp long shaft now it is a tiller steer like i...