Recent content by dahut

Yep Sent from my LGL31L using Tapatalk

All kinda! Sent from my LGL31L using Tapatalk

Lurking Sent from my LGL31L using Tapatalk

"...Also, hope it don't turn into another project, bare bones with a few necessities should suffice, but I think we all heard that before!" Yep Sent from my LGL31L using Tapatalk

At times like this, I like to ask the most basic question of all: "What does the manufacturer recommend?" I'm anything but an expert, but I doubt the exhaust manifold gasket is considered an element of routine maintenance. In fact, just taking things apart because you can presents its own...

So what was the question, again? Sent from my LGL31L using Tapatalk

Yeah these are intended to be mounted in automobile wheel wells, or beneath the running boards. Water proof is probably a gimme. But I'll get a secure mounting for 'em. Thanks again for the tip Sent from my LGL31L using Tapatalk

I found several 12v red LED strip lights somewhere, years back. They were on clearance so I got them. My plan is to use them as you guys have. Thanks for the tips Sent from my LGL31L using Tapatalk

You're right - a bulletin was issued in Sept 1988, recommending, and I quote "... a fuel-oil mixture of 50:1 be used on all recreational motors previously recommended for 100:1, when the motors are only used periodically and during the time of non-use the motor is stored in an area of high...

I was in the Navy - only red lights at night. Warships at sea. Lotsa experience at night. Be like the Navy. Sent from my LGL31L using Tapatalk

Can you show us what you mean? I'm familiar with the UV lighting, bit not sure whats up with blue. Sent from my LGL31L using Tapatalk

Welcome. Sent from my LGL31L using Tapatalk

What's the capacity tag say? Sent from my LGL31L using Tapatalk

Yours right that's actually primary Fuel/oxygen mix, next Then, properly timed spark. I was just reading that last night. My thinking was just a little off - thanks for the correction! Sent from my LGL31L using Tapatalk

Follow the manufacturers recommendations. The following is for reference only: Changes to bearings, materials and construction also accompanied any EPA requirements at the time. For example, my Johnson/Evinrude manual is very specific about where the line is drawn. Engines from 1985 and later...