Here are pics of the reassembly process. I placed marine vinyl on the main floor and then used a marine carpet that my local HD had in stock for the remainder. I had samples from some online marine carpet places and compared the two. They were about the same quality so I went local because of...
I ended up ripping out all of the factory foam because it was severely waterlogged and I wanted to do a thorough leak test. After the foam was removed, I filled the boat with water to find any leaks. It had one leaking rivet so that was replaced. After replacing the rivet, I used gluvit on...
Update on the project. I have done a poor job maintaining this thread as the boat is now complete and sold. I purchased the boat with the intent to keep it but through the course of the project I acquired a different boat that I have now. I did however take pics of the project from start to finish.
Hi everyone,
I have been using this forum for a few years to gather info. You guys also gave me quite a few ideas and information for a previous build that I have completed but have no pics of. This time around I decided to share the project that I am currently undertaking with my kids. It is a...
I have a 14ft deep V mirrocraft that I am planning on installing a floor in. I want the floor to be low for stability but I am unsure of what to level it off with. Do you go from the bottom of the seats as a starting point or do you use the bottom of the boat in the back as a starting point...