Thanks for thehelp. Here's what I am thinking in terms of my electric layout. The TM wires will be at least 8awg. The wires from the back battery to the switch panel and ground block/bus bar will be 10awg and all the rest probably 16awg. The switch panel will be fused and I will probably go with...
Getting ready to do the wiring on my modification and I have what might be a silly question for you electrical experts...........is there any difference between a "ground distribution block" and a "ground bus bar"?
I have been doing research on it and a guy at work refers to it as a dist...
So I decided to alter my front deck layout just a bit and finally got started on it over the weekend. Here's a couple pix of the new layout and progress to date. The blue square will be my ped. seat base and the pink squares represent 2x2 supports (if needed) from the ribs to the 2x framework...
Bassboy1 - first off, your mods are awesome. Great work. Thanks for the tip on carpeting the aluminum up front. Concerning the aluminum angle on my design - my concern is that with the size of my hatches and only 1.5 inches on the 2x edges it would be insufficient space. That would mean only 3/4...
Nice find. If it were me I would probably run one deep cycle battery just for the TM and then run the rest off the cranking battery. I have done it that way in the past without issue. Good luck with it.
Thanks for the insight. I had been thinking of overlaying the whole front with plywood as you mention but then backed away from it in order to reduce the added weight. Is the structural integrity so great that it trumps the added weight (aside from making it easier to lay the carpet)?
Greetings from PA. I am a new member here and love the site. A ton of information! I am getting ready to begin a mod on my recently acquired Lowe L1648. I will be adding front and rear decks and center flooring. I am going to start with the front deck. Assuming I have done it correctly, I have...