Recent content by IAHunter11

I got carb cleaned actually did it twice. Motor will run for 20 min or so then die. I'm losing pressure in my fuel line bulb. I pump it and starts right back up. I ran it for about 2 hours today with restarting several times. I believe I'm getting gas into my oil. Next step is compression...

I have decided I'm going to try musky fishing. I have a 7' heavy action rod and a Shimano curado cu-201. Will that setup work to throw small musky lures or should I buy something else?

I have a mid 80's honda 7.5 hp 4 stroke that came with a boat I recently bought. I ran it one day and seemed to run ok. Went to run it again and wouldn't start. So I replaced fuel line and tank. Couldn't find connector locally so I used the old one. Cleaned carb and nothing. I changed plugs bc...

Boat is not done but decided to put it in the water anyway. Everything went pretty good. But had some motor issues that I'm going to have to try and figure out.

65

Got a little work done on side boxes today.

I got seat posts in main floor. A few accessories mounted. Now measuring side boxes to shear at work tonight to get them close and jig saw the radius edges.

Hopefully a week or two and it will be all complete. I need to spray trailer also.

I got floor, back, top rail and graphics sprayed.

Floor is finally going in. Cutting all those foam blocks was a pain. I think it should help with flotation.

Well I cut triangles in all my center pieces of foam today. That was a pain I guess I got most of them pretty snug. But its done and will drain. The paint is actually not all that smooth. In fact it's not even paint. I sprayed the entire boat with tintable raptor liner. It is a truck bed liner...

It's getting there slowly I should have put it in garage rain is killing progress. Thanks

Grrrrrrr why didn't I think of that before! !!

There should be room for water to drain. I hope. Should I cut a chunk from middle foam section? back of boat is still open.

I got aluminum sheet cut for my floor. Started putting in foam. It's kind of a pain doing the foam on end instead of flat but I think it will be worth it. I think the foam all the way to bottom of aluminum sheet will help a lot with support.