Recent content by Justaguy442

Ad a splash of seafoam to every tank and your fuel will stay good for months. Also pretty much every gasoline fuel tank is vented,

I have a 6 gallon and everyone told me to get a 3 gallon because of the reduced weight and size. I bought that exact fuel tank and i see no issues with it. If you do get it make sure where the line fits on, is tight, it just screws on. Mine was very loose and i had to tighten it. I have a 15 hp...

Bill Dance announced Garmins new trolling motor. The Garmin Force will come in 24 and 36 volt models.

google, scotty clamp mount.

Minn Kota, MotorGuide, Lowrance, Rhodan all have gps and " spotlock feature " Haswing could get GPS, they actually have good reviews. , also heard Garmin is coming out with a Trolling Motor.

I have a 1996 Evinrude 15 HP 4Stroke on a 14 foot tin. The engine right now has a 9 X 11 Pitch on it right now. I just bought everything last fall and haven't even ran it yet. Prop is a little beat up so id like to change it. Not sure to stay with the 11 P 3 blade or go down to a say 4 blade 9...

Yes those slots. I should have posted a pic for you, but was just leaving the house. Could have saved you 3 hours.

if there is 2 bolts on the back, thats were the bracket goes for the square lights. If they are the rectangle light the bolt head fits up into slots in the back.

I read where is only suppose to mess up the time and date of units.

Tohastu makes their own motor plus mercury 30 hp or less and evinrude motors 15hp or less i tihnk.. But i highly doubt you can go wrong with any of your listed engines. Yamaha run forever, Hard to find anything bad about a Suzuki, Honda has been building small engines forever. Mercury and...

So i was doing some research into the car tire vs Trailer Tire and they talked about trailer sway. My nephew has a 14' tin on a trailer with car tires and my brother mentioned it sways but they figure its because the tongue is longer then usual. So after reading this i will change my opinion and...

I had 12's x 4 bolt on my 14' tin and i upgraded to 13 x 5 bolt. Alot bigger and wider which i believe will work better on gravel roads. I dont buy the car tire excuse on light boats. If they are both radial tires then the side walls are thin on both, unlike a bias. On heavier boats id say...

I think the only issue is getting enough water into the motor to keep it cool, so as long as that happens keep on boating. I have a short shaft 15 hp that ill be trying out on my big boat, The centre of the prop will likely be even with the bottom of the transom maybe if im lucky. Only going 2-3...

I can fit a LUND 1775 impact with a 115 on the back in a 22 foot garage easily . In the summer the boat gets the garage and in the winter i put car dolleys under the tires and push it against the wall and the wife parks beside it with no problems.

LDUBS: my big boat gets all the nice ramps and cement pads. My 14' tinner is for all the little lakes that dont even have a dock and defiantly no cement pads. Last fall the water was so low you would have had to back the trailer tires 10 feet past the end of the pad.75% of guys up here power...