Recent content by justinsain1026

Does anyone have a 12 foot or longer semi V boat on a pwc or jet ski trailer? If so Id like to see some pictures on how your setup. Thanks

My boat never had a hole for one either. I would go with a U bolt with some type of backing piece. If you used one I bolt it might wallow out over time in that thin aluminum.

My setup was like yours. I bought a stainless steel bow eye . I used an old screwdriver handle as a backing lol

Should I mount them here, or not a good idea?

With the way this winch post is I don't see a way i can get the bow eye under the stop. I don't want to install a bow eye too low on the boat, or cut off the bow stop bracket because its welded on. I guess ill try to get the bow eye and winch strap hook as straight as possible with each other...

How far above the bow stop do you think?

Trying to set my trailer up but i need to install a bow eye. Should i place it above or under the bow stop? I don't have any adjustment on this bow stop because its welded in place. The winch is in the only place it can go as well.

I'm going to try some of that paint, where did you buy it? thanks

Thank you everyone, I got all the information I needed. :lol:

Does the weather hurt an aluminium boat by leaving it outside?

I love the front deck, can you tell more on how you made it? I would like to make one but without the gas tank cut out. Thanks

Nice boat, how did you clean the outside aluminium?

Nice job on the bow stop

Still got some work to do, but getting close to being ready. Need tires and gotta figure out what i am going to do with the winch post.

What are your plans for seating?