i used marine grade on my new transom but the wood that came out was PT that my uncle put in there over 20 years ago. it didnt have any pinholes or any oxidation at all so mabey he had it sealed up really well from getting any kind of water into it? i should think you should be okay with...
that paint looks really nice. you hit that nail on the head. i'm gettin that spraygun from harbor freight too. figured it would do the job. i will check out your thread. my boat will be used for fishing/duck hunting. so the deck i'm putting in is going to be removable and small like the...
i will post more pics tomarrow. finished gutting everything. i can now start prepping it for paint. i'm not sure if i'm gonna go with the green or tan yet. kind of leaning toward the tan. anyone have a recomendation for a cheap paint that will last for a couple years? my friend usede a oil...
<----- living proof right here lol. mine did anywhere from 48.6-51.9 on a gps on a choppy day and i didnt see that transom budge. the stock one that was supposed to hold 25hp flexed with a 9.9 on it. there is a guy up the river from me that runs commercial fishing and his boat has a 150...
so much for the boat ride!! i got all the way to the filling station and realized that someone liked my gas tank a lot better then i did! :evil: . so off to farm and fleet i went and bought a new fuel line and my friend had 5 tanks laying around so i'm all squared away again. it is a marine...
thanks buddy. i will keep you guys posted with pics. as for now i'm gonna go dip it in the water and scoot it around for a while. ITS FATHERS DAY! hahaa :beer:
use pressure treated. or some kind of marine plywood. i used two pieces of 3/4" treated on my 16.5 footer. and i sandwhiched it together with guerilla wood glue from both sides with drywall screws and i have a 50hp on mine. it is more sturdy then the factroy one with a tiny little motor i...
i have scince taken out the front deck too and all the wood except the transom is gone. this is a console model so there is no center bench so i have a huge floor to work with. what would be the strongest lightweight bracing to use. i thought of taking aluminum angle iron and bending the ends...
i am the owner of a free 1652 monarch flat bottom that i got from my uncle after he knocked the lower unit off of the motor that was on it. i purchased a 1974 50hp merc tiller off of craigslist for 300 dollars with only a few wires i replace and i cleaned out the carbs and made sure it was...