i like the quitness of the 4 stroke .if the e-tec is as quiet as the 4 stroke i would git one of them. can`t aford a new one guess i will have to wait till there is a good used one for sale :)
WINTERIZE :) that is when i do most of my fishing . take the bottom oil plug out and see if it has water [ oil looks like chocolate milk ] . if you live way up north you can`t run the boat for several months . yes winterize .if you have ethonol in the gass drain it . it has a short...
you need to post the make modle and year . some one might have one. post the probablem . you may not need the foot just parts .the biggest thing i have seen is a busted housing bent shalft . berring could be bad from running with no grease or water in the foot.that should be...
you can never run all the fuel out of a carb . you run it till it quits there is just a little left in the bottom of the carb. bol. it will dry up in a few dayes . if you leave it full it will take weaks to dry up .if storing for a long time drain the bowl.for a few monts just pump it full...
you need to find out the sujested rpm`s at wot . then prop it to that unless you are pulling skies or tubes and such . 2 stroke are made to run wot most of the time .
sounds like it needs a carb cleanning .ifit has a idle air ajustment try opening it a little counter clockwise . that sounds like a leanpop . i have run gass 6 monts old . never let a outbord sit that long
after seafoam i think it is recomended to change plugs . and running 2 cans in a row i think is to much.
change plugs and re mix gass to proper mix and no seafoam .
my 1979 55 hp run the same with me alone and another man thesame size 235 lbs. using the same GPS a garman 72
don`t have the float a justment for that carb but it would probabley need to be level with housing when turned upside down . just did s csrb for s 48 hp evinrude thst is the way it was when open it was 3/4 " from housing .the kit should have instructions with it . turn upside down...
that is normal for water and exhaust to come out of the 2 holes . also water comes out of the little hole unde the powerhead . it is onleya indicator that the water pump is pumping . the cutting off sounds like the carbs needing cleanning . ther might be a idle speed ajustment on the...
you could have a exaust leak under the hood where the power head bolts to the foot . or where the shift rod goes into the foot . remove the hod and see if it helps .it could be the carbs need cleaning . low speed jets clogged .