Recent content by Remington351

Hi Guys, I need some help with my 1980's Alumacraft Lunker rebuild. I need to replace the transom board, but am not sure how to remove the cap. The transom is a solid, single sheet of 3/16 aluminum with this 6 inch board at the top as shown. The cap seems to be spot welded to the transom. Do I...

Hi Guys, I'm resurrecting this thread because this is the exact point that I'm at in my build. I started a thread on pinhole leaks in the mod vee section if you want to see pics. On my Lunker 16 the floor rises about 1.5 inches from along the keel from the rear bench to the front bench. My...

Here's the progress from today.

Thanks for the reply. I scrubbed it more; although it is freckled over a large area, there are only a few others that are actually pitting. Would filling the boat with a baking soda solution neutralize the existing freckles?

Hi Guys, I'm a new boater and need your advice to make sure I'm being safe on the water. A quick history as follows. Bought this boat January of 2020, 1983 Lunker. I knew it was older but was attracted to the CG sticker showing useful load of 990lbs. Being new I didn't want to be overloaded. The...