If you remove the middle bench you can run floor supports front to back and that will give the boat a lot of support. I connected my floor supports to the front and rear benches.
I like those boats. There's so much that can be done with them. You're getting a good start at the worst part of the job. Lol. Just make sure to put foam back in and don't use pool noodles for foam.
What are your plans for the rebuild?
Great platform to build from. I'm keeping my eye out for something like this. I've done a 14ft boat and I'm gonna redo it if I don't find a nice boat like this over the winter. I like the idea of the open floor plan for trolling. My plans would be similar but I would probably build a removable...
That's a great boat to start with. Best way to pinpoint leaks is to put about 3 inches of water in the boat and get under it and watch for leaks. You'll not only know if it leaks/how bad but also where from.
If any rivets are leaking don't just try to seal them. Tighten (buck) them first then...
I hope you enjoyed your time in Oklahoma and got to fish a little while you were here. I've worked all over NC as well. Lol.
So you're just taking those panels and using 5200 to connect them? That's an interesting idea. I don't think I've ever seen that done before.