Recent content by sleblanc

man do you have any more photos on the pods i am really needing to build a set for mine. did you build these or buy them? any more info on your pods would help me greatly.

Will just have to get it welded then I worry about using a patch and 5200 where the transom and bottom meet unless you guys think that would hold? But of course the best I am sure is to still weld it. What are your thoughts?

hey guys i got a couple long holes on the bottom of my transom where is got dropped out of a truck and i was thinking of trying to get some brazing rods or something similar from Tractor supply to fix these. i dont have access to a mig setup for aluminum. but i think these brazing rods may work...

https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=5&t=44344 also another rig i really like it runs really well with two people and that mud motor. here is the photos of what i am starting with.

https://www.youtube.com/watch?v=WEj3O1JWr08 i really like this setup but with a smaller front deck and keeping the rear bench seat in.

hey man thanks for the reply. we are currently duck hunting two people out of a welded 1248 (was a 1648 that was cut) with 25hp two stroke and gear. on occasion we will have three people in that boat to get to deer stands and such and some times even three people and a deer in the boat. which is...

https://www.refugeforums.com/refuge/showthread.php?t=499172&page=4 this is an extremely large example of what i am thinking of adding. i wouldnt go more then 12in setback on the section and angle it up about 5-6degrees on the bottom like they do with the pods. and maybe bring the motor in some...

Guys i am new to the site and figured i could just start my build thread i hope some of you give me pointers along the way. i have zero money in this setup, this is a budget duck boat build. to start i was given a suzuki dt15 a 1989 model. and another person gave me a 1436 lowe that needed the...

excellent build i have the same boat. it was given to me. i need to cut the transom off however and the pods in the back were cut out. so i have a little work to do. what did you use for the floor,sides, and decking. i see it was all built with aluminum angle framing.