You think the transom on the G3 1756 can handle the weight? I'm just curious as I have noticed some of the weights being close to the same. Guys here in my area say a 4stroke 90/65 is too heavy? I am asking the pros on here. Thanks for your input. I'll keep my eyes open for a 90/65 first then if...
I have a 1756 dlx G3 center console, I am wanting to upgrade from my Mercury 45 jet and all I can seem to find a 4 strokes. Would a 90/65 Yamaha or Mercury be too heavy? I have also considered going to a 2 stroke 115/80 as I have found a few of those in 2 stroke. I want to plane out with a load...
I pump mine until hard, but while operating I have tried pumping and it doesn't change. It only does it once in a while and after the carbs are clean it won't do it for a while
I plan on hopefully changing all my lines as this is twice now in just a few months that I have had to clean the carbs. I just wonder why at wot the motor seems to have a stutter? Also is there a way to adjust RPMs? I think it needs more RPMs. It starts perfect and life's fine. I can pull back...
I pulled the carbs off today and they were full of small black crud. I did notice the other day in the gas tank the same foreign material so I dumped it all out best I could. I plan on taking the boat out soon so hopefully it helped! Although last time I cleaned then it helped but it still...
no i just cleaned them and didnt see anything out of the ordinary. But i am not really a marine mechanic. I hate to take it and pay all that money but i am running out of options. It had a rubber needle under the float it looked good.
I have a 2000 Mercury 45 jet, it is leaking gas out the carbs when running. I have took the carbs apart and cleaned didn't notice any issues. Also on the top end running wide open it has a small stutter. I believe it's a fuel issue but not sure where to start? The marina wants 95 dollars to...
I ran a bottle of seafoam through the tank and went fishing last night, my buddy 285 me 260, 2 18 pound anchors, live well full of bait and cooler full. Along with all our gear and we ran 25 down river. The motor seems to be running a lot better where it's at!! It feels fast at night on the...
I'll have to slot motor bracket or drill new holes in transom to go up any higher. I thought about moving console to the front so I could see better at night running the river. I think i'll just leave it alone though.. I hope to paint the boat soon and but some type of roll on rubber for the...
I also have a trolling motor and 2 batteries, I have thought about taking it off and taking one battery out as i primarily catfish and with it being a 40 lb thrust its more or less useless on the river. I have the trim set to where my hole shot is a little slower but my top end is better. I had...
I took boat out today and I did gain some after I trimmed motor up a bit (manual trim). Also I tightened my breather up a bit in my tank and it seemed to help. Im hoping to figure out rpm issue, I'm thinking it's an air leak somewhere? I do now have more spray than before. Mabye in a year or so...