Search results

So if i order the LED strip and the ON/OFF switch then i will just have to buy a fuse to connect them with the battery?

What type of fuse would i use? where is the ground on my battery?

Im not sure im followin ya. Like i said, im not to good with wiring and electronics.

I'm about to install LED light strips on my casting deck. but i cant figure out the best way to do it. They would be wired to my trolling motor battery. ( my TM is old so theres no plug just +/- clamps). Im looking to put a strip on each side of the deck. Also I would like to have an on off...

Picture if the bottom as of right now

So i got the 5200 on all my seals nd rivets yesturday. It went on fairly easily and is drying quick. Now im just waiting on the primer and hardener to arive in the mail. Before i apply the zinc chromate primer do i need to remove all paint or just rough it up ?

Like rustoleum marine paint or is there a certian type of paint to use. What about paint hardeners

And do you have any suggestions on what paint to use

Actually i got the quick setting formula. And it only takes a day to cure fully

So i got the 5200 and am waiting for the weather to improve to put it on. But after i hit the spots with it. Is it okay to paint over? I planned on using a marine paint with a hardener in it. I heard steelflexwas goodtoo. What do you guys think

it says its waterproof on the website, yet it doesnt say to what extent. Would you think this is just a fancier version of JBweld

Yes, i see your point now. And have decided against it. And i would be trying to replace the rivets, but dont you have to have access to the floor of the boat to do that?

Just doing some looking around and came across this stuff . https://www.net4sale.com/Shop/pc/viewPrd.asp?idcategory=12&idproduct=48 has anyone else used this, or does anyone have any ideas on how well this would work

im interested to see why you say thats a bad plan. IMO if its just a layer over the stuff actually stopping the leaks then what would it hurt to put some on.

Well i would be using the gluvit however my floor and deck are still on the boat. I plan on redoing the boat afyer this fishing season. Then i will be putting gluvit down on the floor

So ive been slowly getting some work done on the boat. I've been grinding off the JB Weld on the bottom of the boat with a wire wheel. I'm getting closer to being done and i have my 5200 marine adhesive coming in the mail. Though i had an old johnson rep come to check out my motor and he gave me...

in

thank you all

the jb weld is on the outside of the boat.

I have a 16 foot semi-v riveted jon, the previous owner of the boat had fixed the leaks in the boat with JB weld. It has several leaks down the spine of the boat. Unfortunately there's around 5-10 years worth of jb weld sitting on top of the leaks and now the jb weld is leaking. I've been...