Search results

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. L

    Why do new jetboats have trim tabs?

    What purpose do they serve? Thanks.
  2. L

    Jet intake fins???

    Do they help in turns? Do they act somewhat like a rudder to help reduce sliding in turns? THANKS
  3. L

    2008 Yamaha 50hp 2 stroke?

    The only down side to a 4 stroke is they typically weigh more than a 2 stroke. Most newer 2 strokes run as clean as a 4 stroke. They must meet the same EPA requirements. 4 strokes do run much quieter than 2 strokes, but require oil changes. If I were to decide on an engine, the most important...
  4. L

    115/90 Jet on 18' john?

    It actually runs 34 mph. No carpet, No interior sides, perforated floor, I only fill the tank with the amount of fuel I'll need that day.
  5. L

    Jet intake fins???

    Thinking about installing these. Do they work? Any info would be helpful. Thanks
  6. L

    Have to keep pumping my fuel bulb

    I had this happen to me on a 150 mercury, It was just the bulb.
  7. L

    115/90 Jet on 18' john?

    I have an 1860 alweld with a 115/80. It runs 35 mph with 2 people, fishing gear, and a full cooler. It has factory welded trim tabs on each side. The boat does not cavitate unless you trim the motor to high, which is about over 25% up. Hope this helps.
  8. L

    Will a 50/35 work on a 1648 .072?

    Just wandering if this would be a sufficent setup, not trying to break speed records.
Top