Search results

Im gonna dump an aluminum bottle of Miller Lite in my Ice Auger carb tonight and see how she cleans up! Thanks for the tip! :mrgreen:

It's called a Manual. 8)

Id mount it where ever you thinks it's convenient. I run a tiller so the priming bulb is right next to where i sit at the back of the boat close to the motor. The tank is up front out of the way, six pack on ice right behind me.

I run this little 9.8 pretty hard also. Since i put a higher pitch prop on her she runs WOT at about 6100 RPM's when i'm solo. She's rated at 5000-6000 so i try to be mindful keeping under 6000. With 2 guys on the boat its not a problem. Would a rod or a bearing make that noise while revving in...

My tank is up front in my 14 Sea Nymph. Never had a problem with it. I'd stand more of chance puncturing something if it was in the back because i throw so much crap (hooks, lures, knives, etc....) behind me when i'm fishing.

You should see what comes out of our 96 225 rude ocean pros after winterizing them...lol

I don't remember. I put the tach on so i could determine the best pitch for a replacement prop. It's one of those simple "wrap around plug cable" types. If the carb was pulling air, would it do it only under a load in gear or would it also do it revving in neutral?

I apologize for horrible the audio quality. If it was a carb pulling air, would it do it only under a load when in gear? Everything sounds normal when revving in neutral. I haven't tried it in reverse. Thanks for the response!

I run a 2003 Nissan 9.8 2 stroke (NS98B) on a 14 Sea Nymph. The motor runs great but every time I throttle her up there is a whining sound coming from somewhere in the motor. It happens at around 1000 - 2000 rpms when i throttle her up to plane and when i bring her back down off plane. It is NOT...

I'm looking to run her tonight again. Any advice on diagnosing the whining noise? I'm thinking about doing another lower unit oil change in the parking lot as soon as I pull her when it's still warm.

A few fishing trips ago I noticed a lack in speed from about 12mph to 6ish mph. Also, there was a faint sounding wheeze I thought I heard coming out of the middle/lower unit. I also put a mark on the prop and when I last hauled the boat I learned my prop hub was spun. Previously the motor ran at...

Thanks for the info. The manual says WOT RPM should be between 5000 & 6000. I'm gonna give a 7 pitch a shot.

Thanks for the reply! I just wanted to ask the question before i pick up a new prop. I installed a Hardline Hour/Tachometer also. When i ran the boat last night with me, fishing gear and a cooler. the tach maxed out at 8900 RPM. After reading the instructions again this morning, The tach comes...

I have 2003 Nissan 9.8 2 Stroke on a 14' Sea Nymph R all original. A few trips ago i noticed a lack in speed. The motor sounds like it's revving normal. Last night i put a small scratch in the prop hub aligned with the cotter pin in the crown nut. When i hauled the boat i noticed the scratch i...

Hi everyone, After kayak fishing for the past 10 years in mostly fresh water and ocean fishing all my life in all kinds of bigger boats I wanted something to fill the void to get me on some bigger New Jersey lakes and rivers. I found a great deal on a mid 90's Sea Nymph 14R with a 03 Nissan 9.8...