Search results

Wow I can't believe I have had this boat two years and I have finally almost got it finished. So I tried to do something different different and it didn't turn out good. So I ended up going with a smoke gray. Don't know why pics are not in order.

Here in Georgia you must fill out a form and let the dnr come out to inspect the boat then they will assign the boat a hull number not sure what you have to do in Florida.

Here is one I built for for my motor

I agree, the plan is to do a leak check after I replace some fasteners in the floor and I am going to be adding foam before the new floor goes down.

Started on pre fitting the storage deck and removed foam from rear bench for storage

Done a little work this weekend

:) yep that's probably what happend.

Just my opinion I wouldn't put a casting deck on it atleast not to fish from I believe it would be to tipsy and you may end up in the water.

If it is not compression and running on both cylinders then the prop would be the only other thing I could think of. Like Zum said go solo and see how she runs.

It could be running off one cylinder.

Hi Bob E this is just my opinion not sure if any one else would agree but I believe a stainless steel fine thread screw would be better than a pull fastener, wet installed using the 3m5200. Have the cracks welded back together and the puncture round out smooth fabricate a repair 1.5 inches...

Have you done a compression test?

I swapped my 1232 for this 1432. The guy showed me where the boat had been dented in by what I don't know. After removing the deck off of it I fond this split that I guess he had tried to fill with what looked like liquid nail. So this is the fix that I have came up with. Stop drill the crack...

Thanks for the welcome.

Hi everyone my name is Shane I live in Dodge county Ga. I have just traded my 1970 1232 flat bottom for a 1965 1432 flat bottom. Looking forward to working on this boat it has a lot of potential. I have been looking at the rebuilds some of you have done and gotten a lot of good ideas of what I...