Search results

Bolting some angle iron to the bunks isn't a bad idea....I'll look into that as an option if I go with a transom saver. Thanks for the advice!

Thankfully my bunks go all the way underneath the end of the boat, would never have thought about checking that so thanks for the advice......only bummer is I can't use a transom saver becase the cross bar of the trailer is too far under the end of the boat so it's not a good angle, it would...

I recently purchased a 5 hp Briggs outboard and am wondering about trailering it. Is it safe to mount it to the back of the boat using the typical spin screws and trailer it on a 2-3hr highway drive? If so, what precautions do I need to make? Assuming i need to tie down the handle to avoid it...

I'm looking for some guidance or links to product that will help me add some storage to the SIDES of my trailer tongue. Wish I had enough room to add a storage box to my trailer tongue but the area is just too short (about 10 inches from the winch to the hitch and my jack is mounted along...

I'd like to use some type of quick connects for the trolling motor and fishfinder so I can avoid having to unscrew the small posts on the terminals each time I hook them up or smitch them to a new battery. I know I can hook the batts, motor and fish finder to a switch and go that route but I...

I'd like to use some type of quick connects for the trolling motor and fishfinder so I can avoid having to unscrew the small posts on the terminals each time I hook them up or smitch them to a new battery. I know I can hook the batts, motor and fish finder to a switch and go that route but I...

I have a Minnkota Endura 50lb thrust motor and recently broke the skeg off almost at the base. Are there any suggestions out there to repair this? or should I order the part and replace it?...not sure how involved that is taking it apart and putting it back together. Any options would be...

or better yet...how do you get to your anchor? I see the line under the eve but the actual anchor looks like its under the hatch up front. Based on your frame underneath it doesn't look like the front section opens to get at the anchor though, do you just use a large clip to attach it to the...

Here's another question. I'd like to have a front deck with two openings, the first opening towards the rear to get at the anchor. The second opening behind the first but opens towards the front. I envision a hinge between the two so one hinge opens both towards each other. The problem is in...

I'm looking at doing a very similar mod to my V-Hull. Question for you.....Is the very most front piece screwed down to the wood frame below, or do the hinges open both the very front section (so you can get to your anchor) and the next split section? If it open both sections (Front section...

That's actually a great low cost route to take. I'll certainly look into that. If you can post some pics thatw ould be great. I did a search on your mod and couldn't find it under Xpress 1546 Makeover. I'll keep looking though. Thanks for the idea.

First request: I'd like to add battery cases to my set up so I can leave them in the boat while in transport and not worry about them falling over and spilling water. Can you guys receommend a few options to me? Unltimately I'd like them to be secure enough to support the batts in transport...

I'm looking into some minor mods to my 2009 Lowe A1457. https://www.loweboats.com/showroom/utility-v/angler/a1457.php Couple questions: 1) When you guys are attaching wood platforms on top of the seats only, how are you attaching them to the seat? With all the foam underneath I'm not sure...

I'm looking for a Guest u-3632-p wire extension kit but am unable to find one. I contacted marineengine.com and ibotas.com which are the only two I found online, in each case they are out of stock and the manufacturer has mentioend they are discountinued. Can any of you let me know of...

I currently have (2) 12 volt deep cycle batteries. I've been charging them with a portable charger after each use, but am interested in a better method. It's a pain to charge them individually and keep track of that. They get fully charged before and just after each trip but in between they...