Search results

Fiberglass Supply Depot
TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. I

    trailer adjustment

    The trailer that I bought along with my Sea Nymph Coho 16 is long enough for the boat, but while it fits the boat fairly well, it does not appear to be optimally adjusted (several of the boat supports on the trailer are obviously adjustable to fit individual boats).For one thing, the tongue...
  2. I

    fishfinder latency & "real time"

    A friend was telling me of new fishfinder models with "real time" display technology. He claimed that there was on the order of 10 seconds of latency between when a fish swims by and when it appears on the display for older tech fishfinders. I find that very difficult to believe. While I don't...
  3. I

    inside hull fishfinder mounting

    I have a new Lawrance fishfinder to mount in my Seanymph. I would prefer to mount inside the hull. I have read of several examples that use a small "moat" and water or some other fluid to couple the transducer to the water. Does anyone have pics of an actual working setup that they could share...
  4. I

    Nissan/Tohatsu 40 HP engine evaluation

    I'm looking at a Nissan 40 HP two-cylinder two-stroke (40C) that allegedly has 10 hours total time to repower my Sea Nymph Coho 16. Beyond the usual two-stroke checklist, is there anything I should watch out for the is specific to this motor? Thanks.
  5. I

    mats vs floors

    I do not intend to install floors in my 1973 Sea Nymph Coho 16 (for one reason, if a seam begins to leak, I want to be aware of it immediately, not after water has filled the area under the floor). However, I do want to provide adequate footing, and keep mishandled anchors and other equipment...
  6. I

    Sea Nymph Coho 16 transom restoration

    Finally got around to this. As mentioned in an earlier thread, the previous owner of my 1973 Sea Nymph had done a half-***** transom extension because he had been given a long shaft 40 (?) HP Mercury outboard for free. My single misgiving about acquiring this boat was in regard to what kind of...
  7. I

    help with pre-buy checklist for 1974 16' Sea Nymph

    Hello. I'm in coastal NJ, recently retired. Most recently I have been using a Michicraft T-15 square stern canoe with a 3 HP Gamefisher. It's a pretty good little set-up, but has obvious limitations. For a number of reasons, I'm looking to move up a bit in size, to 14-16' semi-V or V. Intended...
Top