Search results

Hello All, New to the forum and jon boat modifications. I have a 12 ft sea king I am wanting to put a casting deck in. What is the minimum size of aluminum angle that should be used? Could I use 1/16 by 3/4 if I use a lot of upright supports? Thanks in advance

I was just wondering if a 2015 jeep cherokee with a 2.4 would have any issues pulling a 14ft jon boat. The boat doesn't have casting decks. It's a plain jon boat with wood floors 3 bench seats covered in plywood.

I am going to be replacing some bad rivets with stainless steel screws and washers. My concern is should the area around rivet hole be primed with self etching primer , or bare aluminum where I'm going to apply 5200? Or does it really make a difference ?

Could someone please recommend what size Fuses would be appropriate for the items I will be installing. 1. Radio 2. Fish finder 3.12v outlets (one cigarette plug, USB. ) can I tie these two together or should they be on individual fuse and switch? 4. Running light and led strips on...

I am in a dilemma and can't wait until I receive the 3m 5200. Is there another type of silicone I can use to seal out water when replacing bolts thru transom? And that is also paintable. Thanks in advance

Can I mount my bus bar to plexiglass then mount that to wood.

I am going to have toggle switches hooked to radio, running lights, bilge pump, fish finder. It will all be tied to a separate battery from trolling motor. My question is, can I Daisy chain all positives to each positive? I will have 14ga wire coming from battery with online fuse going to...

New guy here. I've been browsing forums since I just got my Jon boat. It is going to be a project. I'm not sure of brand. The guy I bought it from said that he thought it was a Delhi(spelling). It's 14ft and has 3 bench seats. Looking forward to getting help and suggestions from all the...