Search results

The elites killed them here, but it keeps pumping out big fish.

Everyone should hop on @tinboats.net on twitter!

So I put up some pics of what I have. I want to make a small front deck even with the front bench seat. I can attach a bracket of some kind to the seat, but I cant figure out how level it up throughout. If I have a blueprint I can build it no problem (I just cant SEE it, if you know what I...

1979 evinrude 9.9 My cam roller has and indention and I plan to replace it soon, my question is do I have to take off the whole carb to replace it? I took the breather off and it looks like it can just pop off, but I don't want to put that much force on it and accidently break the arm or...

Does anyone have any pics or diagrams of some homemade shallow water anchors to be installed on a 14ft v bottom? I was thinking some kind of PVC creation. Any help appreciated.

Was out smallmouth fishing on Lake St Clair on Friday and this girl decided she wanted my 1/2oz red eye shad. Not in season so returned back to the water safely. But what fun!

So after fixing my o-ring issue on my steel OMC fuel tank the leak at the connector stopped and all was good for 2 weeks. Forward 2 weeks of the tank sitting in the garage (to busy to get out) and the 90 degree heat here in Michigan, I went to fire up the motor before planning on going out the...

Does anyone know where I can order decals for a 1960's JC Penny Foremost boat? Looking for what the original looks like. I can't seem to find anything online. Thanks.

The PO had painted my tin inside and out. Now it is leaking at seams and rivets more than I am comfortable with. Can I use Gluvit or Coat It directly over the paint or will I need to sand down to bare aluminum? The interior is covered with the flooring I installed and would not be visible. I...

So my fuel tank leaks at the gasket when not in use after running and has some pressure in the tank, I just ordered a new gasket for it. My question is do I need to loosen the cap to relieve pressure every time I turn off the motor on the water? The tank is older, has no vent cap, and has the...

So I thought I read on here to remove the spark plugs, spray in the seafoam all around, wait about 4 hours, and then start her up. Does that sound about right? I have a 1979 9.9 evinrude that sat for a few years behind a garage. I already have it up and runnning nicely, just looking to clean it...

In Michigan is there a requirement for the size of oars on a 14 foot boat? I don't plan on using them, it's just for emergency situations.

Looking to put a floor in my aluminum and I'm reading to put in CDX plywood. I'm not looking for it to last forever, just a few seasons before I upgrade boats. I'm not paying for marine grade at this point. I checked online for CDX and Home depot has RTD which I'm thinking is their version of...

So my sea king trailer for my 14ft is from the late 60's or early 70's I think. The rollers on there now are 5" long and only 2 1/2" wide. I can't seem to find any rollers at that width. They all seem to be 3" wide. I have ordered two so far that looked right in the picture only to receive them...

Hello all. New here, been checking out the site for a while. I recently purchased a 14ft aluminum from my buddy's neighbor. I can't find any identification anywhere on the boat, but the registration says 1968 foremost. He painted the entire boat an ugly brown and underneath the brown in the...