Search results

The other thread was diverted. I don't think my question was expertly covered. If I had a vette that needed repair, I would repair it. Thanks for your advice.

The wood is totally rotted out & I have to replace it. On a Gregor, it is not a separate cap, I just used the term for lack of a better way to describe it.

My other thread was hijacked a bit so I thought I try again. Gregor aluminum, 12', 1977. I'm starting the transom repair and came across this crack in the cap. Thoughts on repair? I don't weld, fyi. I think the one rivet was placed by PO. Couple more photos. Hopeless? TIA

I wasn't planning to replace the cap because of the welded corner pieces. Like I said, I don't weld. To get the transom board out/in, I was planning to go the route of cutting, then patching the knees with plates & screws. Which brings up one of my next questions. The knee braces on it are not...

The whole boat.

The sun is out today so I thought I'd start planning the transom repair on my, new to me, 12' Gregor. It's a U-123, confirmed 1977. Here's the cap plate. As you can see in that photo, the transom wood has seen it's last days. I suppose as is usual, there's some surprises found when I moved the...

Is the loose piece which has a notch in it for passing a cable through?

There are four of them on my (new to me) Gregor. Two on the transom facing out, two near the bow on the inside of the boat.