Search results

I fish a lot of electric only lakes and was wondering , all being equal ,does two transom trollers push a boat faster than a single motor?And if it does by how much faster? Example:2-55lb thrust vs one 110lb thrust. Is it close or not worth doing?

What’s involved in changing a factory bilge pump on tracker 195 txw boat to a automatic bilge with float switch.What wiring will I have to run and how should I hook it up? Any help will be appreciate!

What’s the best sealant for screw holes on transom of aluminum boats?Want to seal the transducer screws,but heard certain products react to aluminum. Any help would be greatly appreciate!

Does bare aluminum need to be sanded before applying self etching primer?

I have a 1448 polarkraft that I'm relocating the bench seats in, and would like to use the same kind of rivets to put back in! Does anyone know where I can find these aluminum rivets and what they are called or the size I'll need? Any help would be greatly appreciated ! Thanks.

Hello everyone, I have a 14 ft. Jon boat that came with a trailer that seems to short for it,(at least three ft of boat is hanging off of trailer). Been trying to find some rectangle tubing to lengthen trailer to give support to boat, but can't find any that will slide over 2x3 tubing. What...

Been lurking for awhile and have a question about an all aluminum mod. Does anyone have pictures of an all alum. Mod. with storage compartments? I have all of the alum. angle and the sheet alum. But don't know how to go about adding storage to the decking. Any help would be appreciated. Thanks

I have a 86 mercury 9.9 that I can't find how to tilt the motor when installed on the boat.I see the locking fork but what activates it to move? Any help would be greatly appreciated, the manual doesn't show anything about it. Thanks!

Looking for a clamp Assy. for a 86 mercury 9.9, will pay shipping charges!

I've just purchased a mercury outboard and I'm not sure what hp it is, was told that it was 15. Where are the serial numbers located so that I can check ?

I have a 14 ft. polarcraft flat bottom jon that has a gravity feed livewell in the middle bench seat that i would like to add pumps and aerators to to make it automatic. I dont have a clue how to go about this, if there is anyone that could help me i would be grateful.