Search results

I need help setting up my settings on my Lowrance Elite-9 Ti..I have a 15-52 Alweld flat bottom, I mounted the transducer on a bracket so I can adjust the transducer lower or higher if needed..I’ve taken the boat to small ponds but I don’t know the best setting for the finder..I just want to be...

I have a 55lb thrust I pilot with only the remote (no foot pedal) and looking for a good battery...I am mostly going to use it for the spot lock feature...what do you guys recommend?

Would self drilling screws with loctite and a locking washer hold as well?

Also the motor is not going on angle I’m mounting it straight up and down

It’s actually 2 bolts on each side that would hold the rear of the motor and for the front another 2 on each side also but I want to put the riv nuts on the gunnel because I don’t want to drill a single sheet metal screw into the gunnel..do I just buy any rivet gun or does it has to specific...

Ok so I just received my motor bracket from alweld boats..when I placed the motor on top and positioned it so it hangs off a 1 1/2” off the gunnel it looks like the bracket is too long because when I took off the side plates to expose the mounting holes for the motor I can only bolt 2 of the...

I have contacted alweld and they are sending me the trolling motor bracket now my real big question is what the best way to secure the bracket? Should I have it welded or use some type of screws?

I have a bow mount motor on my flat bottom and I need some help into mounting it to some sort of plate as you can see from the pic there is nothing supporting. The back end underneath..please help if you can

Another thing I wanted to mention is how I should run the wiring because on most boats they have a accessible deck that the wires go to and connect to the battery..my deck is fixed and does not have a lifting deck I just have a storage hole right on the bottom where the deck ends so should I...

This is my boat.. the 2 lines I drew are the ones I was asking on where the motor should be installed or is it my own preference

Another question is the mounting position? I’ve googled images and I seen some where guys had it straight vertical and not on a angle like most are, does it matter how it’s mounted when it’s in the stow position? Or does it have to be on a angle?

I have a 15x52 flat bottom and my deck is 48” wide but it does not open for storage I only have the storage hole, now I want to install a bow mount trolling motor now my question is since I don’t have a lifting deck do I need to fabricate the deck if not will the battery cables from the trolling...