Search results

Thanks, not as nice as yours but I tend to fish in pretty tight spots and hated to paint it and end up scratching the sides.

Engine decals done. Ready for a test run.

I fabricated and added two braces to the transom and splash well. With the 50 HP hanging it moved more than I liked. It really stiffened that area up.

I made one change in the way the rear deck and compartments were configured. At least the way they were when I got it.

It came with a great running Johnson 28 SPL but I wanted a little more power and picked up a newer Yamaha PRO50 with low compression on one cylinder. When I tore it down I found that a small clip had gotten into the center cylinder and bent the top ring groove just enough to make the rings stick...

I wanted to update the decals like other builds so I had a friend make them locally to match the newer style Tracker but I had him print my NC registration numbers on the decal.

Started with the Nautolex. I like the color and its easy to install. I used contact adhesive that came in a 20lb cylinder with the hose and gun.

I didn't take a lot of documentation photos, like I said these guys had all done it before. I stripped It out to the bare hull and removed the decals. Did a lot of cleaning and replaced the foam in the floors and then replaced the wood with marine ply covered on all sides with epoxy. I hate wet...

I picked the boat up a few months ago and came across this site. I'm not going to document my entire build because its all been done here before. I would like to thank Derek, Bowlershop and Jigngrub for their build threads. They all paved the way and made my job easier. The hull was in great...