Search results

So in a few spots on the inside of the boat i have, i will be doing a plywood deck, with a drainage system. WIth that being said I've been stressing over what to waterproof it with. It will be kept on a trailer, indoors so the elements arent a concern. Only time it will get wet is the little bit...

iM THINKING that i will be using 1/8th angle for all the frame when it comes to support, crossbeams and vertical support. Everything else where i can, such as hatch frames and all will be 1/16 attacthed to 1/8th angle.

So rivetting the vertical supports wouldnt be a good idea? Like if i use a 1/8th angle for vetical support, rivvetting the top and bottom wouldnt be good to secure it?

Trying to understand 110% on this 1. I was thinking of using 1/8 aluminum angle. So you think just that alone for cross beams around the inner of the boat is enough? Then on the rivets fold them on the side of the cross beam and rivvet to the outer edge?

So you only used the 1/4 thickness angle for the main frame of the boat and built off that? What did you use for the "extra support" ? Like what sort of vertical support did you use if you used the 1/4 angle? And for the floor and deck? Did you do coosa or plywood over the sheet? Im doing a sub...

I'm looking into buying a 14 foot flat bottom jon boat. I've been watching and looking around for everything related to jon boat builds that i can. Was looking into framing in a sub floor, then moving up and framing a deck with the hatches and all. Im looking at using coosa board along with a...