Search results

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. N

    Richline Challenger: Scrap it or keep it?

    I can't say if you should keep it or not, but I have a Rich Line, and I love it. Tough old boat, and fun. Seems like you have the right idea with straightening it. Patience, patience, patience. Good luck.
  2. N

    REFURBISHED BATTERIES

    I have an Interstate, and I love it. It says "RECON" right next to the positive terminal, but it does have the warranty sticker that shows when it was sold. From what I gathered, they're returned. Not necessarily defective, but returned. I dunno. It was cheap and, like the gentleman said, even...
  3. N

    Transducer placement

    I'm at the 7 ft rooster tail stage with mine... I epoxied mine on because I'm not going to drill holes below the waterline for anything nearly as esoteric as a first position on a finder. I really like the cutting board idea, though. I put some water in the boat last time out and tried to get a...
  4. N

    1969 14' Rich Line Model 15

    Facing the engine from behind the boat the HIN plate on mine is on the top left (starboard? not sure yet) corner of the transom. I'm not sure that there were always numbers put on them. I'm thinking that, earlier on, smaller boats were treated like trailers are today; registered, but not titled.
  5. N

    1969 14' Rich Line Model 15

    Good job! That's a lot of work, my friend. I have a '73 Richline. It's a 14, but it only has two seats. Kind of a nice setup for fishing, but you can't put a whole lot of people in it. Bummer :wink: I have a 15 Evinrude for it that I am finally done going through, and I clocked it at 23.5 mph...
  6. N

    9.9 JOHNSON PROBLEMS

    Hey, Folks. I'm new to the site, and I've been going through my Evinrude 15 recently. Carb rebuild kit a the local discount marine (oxymoron?) is about $40. Rebuild kit for the fuel pump is about $20. New lines under the cowling are not too much, but I haven't had to buy them yet. New pump and...
  7. N

    Decking-When and when not to.

    So, I'm a newbie here, and I love the site. My respectful suggestion when it comes to decking is to wait until you've spent some time getting to know the boat first.
Top