TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
15 hp Johnson J15RCSD tech questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Daretofish" data-source="post: 339266" data-attributes="member: 13319"><p>Hello, 1st time posting, lurker off and on for years. I kew this was the place for the smaller motors when I needed it.</p><p></p><p>On this new to me motor that I am working on, a few things seem "off" after rebuilding the carb and reinstalling, I noticed the reason the idle adjustment knob was cracked. the alignment is not right, the idle adjustment needle is too low compared to the hole in the front of the motor. It seems the powerhead is angled down in the front, mounts look ok, anyone ever seen this before?</p><p></p><p>also, if the starter recoil assembly bolt is tightened it locks up, the rope wont go back in.</p><p></p><p>and third, for now, I noticed a light intermitent sparking between the upper coil mount and block.??</p><p></p><p>thanks for any help!</p></blockquote><p></p>
[QUOTE="Daretofish, post: 339266, member: 13319"] Hello, 1st time posting, lurker off and on for years. I kew this was the place for the smaller motors when I needed it. On this new to me motor that I am working on, a few things seem "off" after rebuilding the carb and reinstalling, I noticed the reason the idle adjustment knob was cracked. the alignment is not right, the idle adjustment needle is too low compared to the hole in the front of the motor. It seems the powerhead is angled down in the front, mounts look ok, anyone ever seen this before? also, if the starter recoil assembly bolt is tightened it locks up, the rope wont go back in. and third, for now, I noticed a light intermitent sparking between the upper coil mount and block.?? thanks for any help! [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
15 hp Johnson J15RCSD tech questions
Top