TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
15 johnson has water at the tell tale hole but still overhea
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="spinfisher" data-source="post: 205723" data-attributes="member: 1944"><p>Thanks For the replies, NoMo, when I had the head off I pulled the water jacket I cleaned it throroughlyand then replaced the thermostat. The port your referring to that had the silt and sand came out, was that the port on the head on the bottom? When i just replaced the head gasket I tried to run a wire up in there and didn't get very far. Is there a small orvice there? I did blow compressed air in that port and the slotted port at the top. I can see now that all it would have done was blow stuff back into the head. What if i removed the left side plate would that allow me to check and clean it better? Thanks in Advance!</p></blockquote><p></p>
[QUOTE="spinfisher, post: 205723, member: 1944"] Thanks For the replies, NoMo, when I had the head off I pulled the water jacket I cleaned it throroughlyand then replaced the thermostat. The port your referring to that had the silt and sand came out, was that the port on the head on the bottom? When i just replaced the head gasket I tried to run a wire up in there and didn't get very far. Is there a small orvice there? I did blow compressed air in that port and the slotted port at the top. I can see now that all it would have done was blow stuff back into the head. What if i removed the left side plate would that allow me to check and clean it better? Thanks in Advance! [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
15 johnson has water at the tell tale hole but still overhea
Top