TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
15 johnson has water at the tell tale hole but still overhea
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="spinfisher" data-source="post: 206351" data-attributes="member: 1944"><p>Thanks ,Pappy. I did remove the lower unit last night. Everything came out fine and the impellor is a definite must replace. I was able to check the gormmets and appear to be good. While I had the lower unit off, I removed the tell tale nozzle and shot some wd-40 up in there and waited, then blew some compressed air up into the hose. I did the same thing on the water pump tube. While I was blowing air out of the water pump tube I was hit by something out of the pee hole line! Maybe that was my obstruction. Any way I bolt it back together and ran it . The motor did not get as hot as it was getting and cool down alot faster than before. I used my infared Thermometer and it was showing 145-160 deg. on top of the power head and 120- 140 on the water jacket. What is your thoughts? Thanks Everyone!</p></blockquote><p></p>
[QUOTE="spinfisher, post: 206351, member: 1944"] Thanks ,Pappy. I did remove the lower unit last night. Everything came out fine and the impellor is a definite must replace. I was able to check the gormmets and appear to be good. While I had the lower unit off, I removed the tell tale nozzle and shot some wd-40 up in there and waited, then blew some compressed air up into the hose. I did the same thing on the water pump tube. While I was blowing air out of the water pump tube I was hit by something out of the pee hole line! Maybe that was my obstruction. Any way I bolt it back together and ran it . The motor did not get as hot as it was getting and cool down alot faster than before. I used my infared Thermometer and it was showing 145-160 deg. on top of the power head and 120- 140 on the water jacket. What is your thoughts? Thanks Everyone! [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
15 johnson has water at the tell tale hole but still overhea
Top