TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
16 ft aluminum
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="DaleH" data-source="post: 441154" data-attributes="member: 15636"><p>I've done the same to tins 12, 14 & 16' and the flex never bothered me. At least it was a 'flat' surface to walk on. I coated the ply, especially the end grains (used epoxy, as I had gallons on hand) and put marine vinyl on them and they'll last for years! Vinyl was folded over the side edges and stapled down w/ monel staples. Fore/aft edges left long, 1-1/2" or so. Floors were light & easy to remove for annual cleanings, pre or post-season.</p><p></p><p>Simple ...</p></blockquote><p></p>
[QUOTE="DaleH, post: 441154, member: 15636"] I've done the same to tins 12, 14 & 16' and the flex never bothered me. At least it was a 'flat' surface to walk on. I coated the ply, especially the end grains (used epoxy, as I had gallons on hand) and put marine vinyl on them and they'll last for years! Vinyl was folded over the side edges and stapled down w/ monel staples. Fore/aft edges left long, 1-1/2" or so. Floors were light & easy to remove for annual cleanings, pre or post-season. Simple ... [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
16 ft aluminum
Top