TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
16' Lowe Line
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="River Rider" data-source="post: 119139" data-attributes="member: 2087"><p>Ok. After a long break from fishing for hunting I am slowly preparing my budget for finishing my boat. The inside is stripped, the transom finished, and the pods done. I am starting fresh this year with ideas from everyone on here. I have decided to mount the pods and take for a test spin before permanently mounting and then I will post the latest picks after that. I have been pondering on some motor issues as of lately. I want to be able to keep an eye on what is going on with it and was wondering if there was a way to wire in a water pressure gauge and a temperature gauge. I want to be able to monitor my motor without constantly looking at the tell tale. It is a 30 horse evinrude that came off a Boston Whaler so I am sure they had to have it monitored before I put in on my tinny. Once I can figure that out I will be able to see where I want to go with the rest of the modification. I also posted on the motor section about finding a way to rig up an extension for my shifter so I am not always turning around to shift my motor out of gear. Any suggestions, or answer will be greatly appreciated. It is time to get back to fishing. Thanks.</p></blockquote><p></p>
[QUOTE="River Rider, post: 119139, member: 2087"] Ok. After a long break from fishing for hunting I am slowly preparing my budget for finishing my boat. The inside is stripped, the transom finished, and the pods done. I am starting fresh this year with ideas from everyone on here. I have decided to mount the pods and take for a test spin before permanently mounting and then I will post the latest picks after that. I have been pondering on some motor issues as of lately. I want to be able to keep an eye on what is going on with it and was wondering if there was a way to wire in a water pressure gauge and a temperature gauge. I want to be able to monitor my motor without constantly looking at the tell tale. It is a 30 horse evinrude that came off a Boston Whaler so I am sure they had to have it monitored before I put in on my tinny. Once I can figure that out I will be able to see where I want to go with the rest of the modification. I also posted on the motor section about finding a way to rig up an extension for my shifter so I am not always turning around to shift my motor out of gear. Any suggestions, or answer will be greatly appreciated. It is time to get back to fishing. Thanks. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
16' Lowe Line
Top