TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
1959 Duracraft V-Hull Project
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="jdspringr07" data-source="post: 333582" data-attributes="member: 13011"><p>I just purchased a heatgun (700 farenheit - 1000 farenheit). After letting the stripper sit on for about 5 minutes, I quickly go back and forth over the surface on the highest setting. It "cooks" up the stripper a little better in colder weather conditions. I scrape off the first layer, then appry a light coat of stripper on the remaining surface. It appears to pull up the paint pretty well this way.</p><p></p><p>I'm going to wait until tomorrow when I can do the second coat with a pressure washer. I'm also going to setup a plastic debree catcher around the boat as well so paint and stripper doesn't fly everywhere.</p><p></p><p>Also, I'm looking at going the for one of the following color schemes: 1) Woodland Camo 2) "America" - Red (below water line), white (above water line), Blue (interior - still considering a blue polyurthean coating (i.e. rhino line, linex, etc)).</p></blockquote><p></p>
[QUOTE="jdspringr07, post: 333582, member: 13011"] I just purchased a heatgun (700 farenheit - 1000 farenheit). After letting the stripper sit on for about 5 minutes, I quickly go back and forth over the surface on the highest setting. It "cooks" up the stripper a little better in colder weather conditions. I scrape off the first layer, then appry a light coat of stripper on the remaining surface. It appears to pull up the paint pretty well this way. I'm going to wait until tomorrow when I can do the second coat with a pressure washer. I'm also going to setup a plastic debree catcher around the boat as well so paint and stripper doesn't fly everywhere. Also, I'm looking at going the for one of the following color schemes: 1) Woodland Camo 2) "America" - Red (below water line), white (above water line), Blue (interior - still considering a blue polyurthean coating (i.e. rhino line, linex, etc)). [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
1959 Duracraft V-Hull Project
Top