TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
1967 9.5 hr johnson need help please
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="imgonnamissher" data-source="post: 203955" data-attributes="member: 5131"><p>Did you turn the carb upside down with the float on to set it?? I should be parallel (or just a little higher than parallel) to the housing (the top part of the bowl) when it is upside down.</p><p></p><p>How did you set your high and low speed needles? Just off the top of my head, if I remember right, I think the low speed needle should start around one turn open and the high speed about 1 1/2 turns open. Then adjust from there once motor has been running for a bit to get up to operatingin temp. Adjust the high speed (at WOT) needle first, then the low speed(at idle).</p></blockquote><p></p>
[QUOTE="imgonnamissher, post: 203955, member: 5131"] Did you turn the carb upside down with the float on to set it?? I should be parallel (or just a little higher than parallel) to the housing (the top part of the bowl) when it is upside down. How did you set your high and low speed needles? Just off the top of my head, if I remember right, I think the low speed needle should start around one turn open and the high speed about 1 1/2 turns open. Then adjust from there once motor has been running for a bit to get up to operatingin temp. Adjust the high speed (at WOT) needle first, then the low speed(at idle). [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
1967 9.5 hr johnson need help please
Top