TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
1968 18 hp Evinrude Low Idle Screw Problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="SumDumGuy" data-source="post: 336526" data-attributes="member: 12459"><p>Pappy is right though. The carb should be properly rebuilt. </p><p>If the needle/nut has new packing washers it should work fine. Typically the only issue you'll run into with new stuff is the needle will be somewhat difficult to turn (which is good 'cause it has a good fit with the washers and thus a good seal - and the nut should not back out).</p></blockquote><p></p>
[QUOTE="SumDumGuy, post: 336526, member: 12459"] Pappy is right though. The carb should be properly rebuilt. If the needle/nut has new packing washers it should work fine. Typically the only issue you'll run into with new stuff is the needle will be somewhat difficult to turn (which is good 'cause it has a good fit with the washers and thus a good seal - and the nut should not back out). [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
1968 18 hp Evinrude Low Idle Screw Problem
Top