TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
1973 Evinrude 25hp Questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="crazymanme2" data-source="post: 226869" data-attributes="member: 1634"><p>When you change the lower unit oil if it has water in it re-seal the lower.Also put some 2 stroke oil in the cylinders before turning over since it has sat 6 years.Sounds like you have most of the bases covered.</p><p>It might have low compression since it has sat 6 years.Possibly run some sea foam through it to loosen the rings up after you get it going.Points on your motor are set at .020.</p></blockquote><p></p>
[QUOTE="crazymanme2, post: 226869, member: 1634"] When you change the lower unit oil if it has water in it re-seal the lower.Also put some 2 stroke oil in the cylinders before turning over since it has sat 6 years.Sounds like you have most of the bases covered. It might have low compression since it has sat 6 years.Possibly run some sea foam through it to loosen the rings up after you get it going.Points on your motor are set at .020. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
1973 Evinrude 25hp Questions
Top