TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
1976 Evinrude 15hp dies
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Stumpalump" data-source="post: 443956" data-attributes="member: 13140"><p>I pulled the float and needle. The needle looked good and I blew carb spray and compressed air thru the holes. It did not look bad at all inside and the float looked like it hung corectly. The line going from the pump to the carb was shot but that got replaced prior testing it. The tank and hose run great on other motors I have. If the pump is bad could the bulb stay hard? I could swap pumps with a 6hp I have. Same pump.</p></blockquote><p></p>
[QUOTE="Stumpalump, post: 443956, member: 13140"] I pulled the float and needle. The needle looked good and I blew carb spray and compressed air thru the holes. It did not look bad at all inside and the float looked like it hung corectly. The line going from the pump to the carb was shot but that got replaced prior testing it. The tank and hose run great on other motors I have. If the pump is bad could the bulb stay hard? I could swap pumps with a 6hp I have. Same pump. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
1976 Evinrude 15hp dies
Top