TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
1982 Evinrude 9.9... NO NEURAL?!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Pappy" data-source="post: 276878" data-attributes="member: 3278"><p>Starting with the throttle gears.</p><p>Order replacement gears, bushings, and pin. In order to remove the gears you will probably have to remove the manual starter. Get a long enough 3/8" bolt and nut to clamp the starter assy together while removing it so it doesnt fly all over the place. </p><p>Going from memory I believe you need to remove the idle stop adjustment also. This is the knob and plate that comes in from the port side of the motor pan.</p><p>Pull the pin out of the center of the lower throttle gear. Remove both gears.</p><p>You may need to remove, disassemble, and thoroughly clean the tiller handle assy at this point and re-lube. Wouldn't be a bad idea. </p><p>Re-assemble and check throttle operation.</p></blockquote><p></p>
[QUOTE="Pappy, post: 276878, member: 3278"] Starting with the throttle gears. Order replacement gears, bushings, and pin. In order to remove the gears you will probably have to remove the manual starter. Get a long enough 3/8" bolt and nut to clamp the starter assy together while removing it so it doesnt fly all over the place. Going from memory I believe you need to remove the idle stop adjustment also. This is the knob and plate that comes in from the port side of the motor pan. Pull the pin out of the center of the lower throttle gear. Remove both gears. You may need to remove, disassemble, and thoroughly clean the tiller handle assy at this point and re-lube. Wouldn't be a bad idea. Re-assemble and check throttle operation. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
1982 Evinrude 9.9... NO NEURAL?!
Top