TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
1990 Bass Tracker TX17 won’t drain water. Help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="kofkorn" data-source="post: 474344" data-attributes="member: 7076"><p>Removing just the center floor isn't too bad. You have to take out the console and the two seat frames (the seats are different on the TX though). I ended up needing something to pull the floor out afterward. It took some serious force, but I didn't want to cut it up. If you cut it, just make sure you go between the supports, or don't fully cut through the entire plywood thickness. </p><p></p><p>The rear deck is far more challenging. I had to take it out piece by piece. Drill rivets and remove. Even then, I had to cut a lot of the foam out, as it held pieces in place.</p><p></p><p>It's not a weekend job.</p></blockquote><p></p>
[QUOTE="kofkorn, post: 474344, member: 7076"] Removing just the center floor isn't too bad. You have to take out the console and the two seat frames (the seats are different on the TX though). I ended up needing something to pull the floor out afterward. It took some serious force, but I didn't want to cut it up. If you cut it, just make sure you go between the supports, or don't fully cut through the entire plywood thickness. The rear deck is far more challenging. I had to take it out piece by piece. Drill rivets and remove. Even then, I had to cut a lot of the foam out, as it held pieces in place. It's not a weekend job. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
1990 Bass Tracker TX17 won’t drain water. Help
Top