TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
1995 Mirrocraft MV 860 NEW to me
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="zekepa" data-source="post: 479951" data-attributes="member: 26147"><p>Pulled a bonehead move today. The bow of the boat had the crack in the first picture on the "V" of the bow. When I had the cracked ribs and transom welded the welder added a patch on the inside of the bow. </p><p>[ATTACH=full]108121[/ATTACH]</p><p></p><p></p><p>Pic of the patch on the inside of the bow. Today I was checking how the front deck fit. The front at the "V" wasn't fitting as the "V" was pushed in. So I got out the 3lb alignment tool (Hammer). </p><p>[ATTACH=full]108122[/ATTACH]</p><p></p><p></p><p>About the third swing I missed the patch and hit the original hull and cracked the weld. </p><p>[ATTACH=full]108123[/ATTACH]</p><p> </p><p></p><p>Any opinions on just using epoxy the make it water tight again?</p></blockquote><p></p>
[QUOTE="zekepa, post: 479951, member: 26147"] Pulled a bonehead move today. The bow of the boat had the crack in the first picture on the "V" of the bow. When I had the cracked ribs and transom welded the welder added a patch on the inside of the bow. [ATTACH type="full" alt="20200824_095552.jpg"]108121._xfImport[/ATTACH] Pic of the patch on the inside of the bow. Today I was checking how the front deck fit. The front at the "V" wasn't fitting as the "V" was pushed in. So I got out the 3lb alignment tool (Hammer). [ATTACH type="full" alt="20201230_163634.jpg"]108122._xfImport[/ATTACH] About the third swing I missed the patch and hit the original hull and cracked the weld. [ATTACH type="full" alt="20201230_163646.jpg"]108123._xfImport[/ATTACH] Any opinions on just using epoxy the make it water tight again? [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
1995 Mirrocraft MV 860 NEW to me
Top