TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
3m 5200 surprises
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="BloodStone" data-source="post: 260199" data-attributes="member: 826"><p><strong>What about using JB Weld? When I take out screws or bolts out of aluminum boats (mainly the ones above the water line), I go with JB Weld. After it's fully cured (usually in 12 hours), I prime it, then paint over the repair. But I've also used 3M 5200 on holes near or below the waterline. And almost exclusively on fiberglass boats. I agree it's pretty good stuff (be careful not to get a lot of it on your fingers #-o ).</strong></p></blockquote><p></p>
[QUOTE="BloodStone, post: 260199, member: 826"] [b]What about using JB Weld? When I take out screws or bolts out of aluminum boats (mainly the ones above the water line), I go with JB Weld. After it's fully cured (usually in 12 hours), I prime it, then paint over the repair. But I've also used 3M 5200 on holes near or below the waterline. And almost exclusively on fiberglass boats. I agree it's pretty good stuff (be careful not to get a lot of it on your fingers #-o ).[/b] [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
3m 5200 surprises
Top