TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
8' Jon boat
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="onthewater102" data-source="post: 365510" data-attributes="member: 13702"><p>I should think so - you'll be following 3M's instructions at that point... The 5200 is still going to solidify and serve as a gasket even if it ceases to hold, and it will be much easier to remove than epoxy if you're not thinking this is permanent.</p></blockquote><p></p>
[QUOTE="onthewater102, post: 365510, member: 13702"] I should think so - you'll be following 3M's instructions at that point... The 5200 is still going to solidify and serve as a gasket even if it ceases to hold, and it will be much easier to remove than epoxy if you're not thinking this is permanent. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
8' Jon boat
Top