TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
80s? Mercury tilt and trim issues or any info available?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Zberry1985" data-source="post: 481709" data-attributes="member: 25580"><p>Picked up a parts motor 0A745967 to take the tilt and trim from. Anyone have a service manual for the tilt and trim? Or know how much fluid it should take?</p><p></p><p> It ran slow up and down to start with, I was hoping it just needed to be topped of with fluid and air bleed out. I raised the motor up and locked it up, topped of fluid ran it a few times letting it sit a few minutes between cycles. It still was running slow so I tried loosening the vent screw and fluid bubbled out violently and I dropped the screw. Went to the store to get more fluid and when I came back the trim motor won't spin anymore as if it's lockedup\binding. I took the motor apart and cleaned the brushes, I can tell it's getting power just not spinning free. Also turned the pump with an allen wrench like the motor shaft, it turned easily but would spin back a bit like it was a little springy. Any ideas why the motor stopped working?</p></blockquote><p></p>
[QUOTE="Zberry1985, post: 481709, member: 25580"] Picked up a parts motor 0A745967 to take the tilt and trim from. Anyone have a service manual for the tilt and trim? Or know how much fluid it should take? It ran slow up and down to start with, I was hoping it just needed to be topped of with fluid and air bleed out. I raised the motor up and locked it up, topped of fluid ran it a few times letting it sit a few minutes between cycles. It still was running slow so I tried loosening the vent screw and fluid bubbled out violently and I dropped the screw. Went to the store to get more fluid and when I came back the trim motor won't spin anymore as if it's lockedup\binding. I took the motor apart and cleaned the brushes, I can tell it's getting power just not spinning free. Also turned the pump with an allen wrench like the motor shaft, it turned easily but would spin back a bit like it was a little springy. Any ideas why the motor stopped working? [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
80s? Mercury tilt and trim issues or any info available?
Top