TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
80s? Mercury tilt and trim issues or any info available?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Zberry1985" data-source="post: 481722" data-attributes="member: 25580"><p>A little hammering and it split in half. The center drive gear was really jammed. Seemed like the end the motor shaft goes in was mushroomed out. There also were some burrs around the hole it's in but that could've been from disassembly. Some fine grit sandpaper and it's spinning free again.</p><p></p><p>Anyone know where those three ball bearings go? Hoping the one picture is right?</p></blockquote><p></p>
[QUOTE="Zberry1985, post: 481722, member: 25580"] A little hammering and it split in half. The center drive gear was really jammed. Seemed like the end the motor shaft goes in was mushroomed out. There also were some burrs around the hole it's in but that could've been from disassembly. Some fine grit sandpaper and it's spinning free again. Anyone know where those three ball bearings go? Hoping the one picture is right? [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
80s? Mercury tilt and trim issues or any info available?
Top