TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
85 evinrude 25hp help gasket
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Tgc1021" data-source="post: 484903" data-attributes="member: 31197"><p>Picked up a very cheap 85 evinrude 25hp motor that needs work. Compression is good but I believe it had a bad power head gasket. Inside the cowl at the base it was covered in oil. Also had oil all over were the power head connects to mid shaft on the outside. Pulled the powerhead and do believe it’s the gasket. I bought this to learn on and am fairly inexperienced so I just want some confirmation. I’ll post pics below along with model/ser #. Also is there normally two gaskets for the powerhead? One on the inside and a second one on the outside of the motor. Sorry I’m still learning the proper terminology. Thanks for any advice/help</p></blockquote><p></p>
[QUOTE="Tgc1021, post: 484903, member: 31197"] Picked up a very cheap 85 evinrude 25hp motor that needs work. Compression is good but I believe it had a bad power head gasket. Inside the cowl at the base it was covered in oil. Also had oil all over were the power head connects to mid shaft on the outside. Pulled the powerhead and do believe it’s the gasket. I bought this to learn on and am fairly inexperienced so I just want some confirmation. I’ll post pics below along with model/ser #. Also is there normally two gaskets for the powerhead? One on the inside and a second one on the outside of the motor. Sorry I’m still learning the proper terminology. Thanks for any advice/help [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
85 evinrude 25hp help gasket
Top